1.5mg of Retatrutide from a 60mg vial in 2.5mL: how many units?

Answer

Draw 6.3 units on a U-100 insulin syringe. A 60 mg Retatrutide vial reconstituted with 2.5 mL of bacteriostatic water is 24 mg/mL, so 1.5 mg is 0.063 mL. That vial holds about 40 doses at this strength.

This page also answers

  • How many units is 1.5mg of reta?
  • 1.5mg reta on a U-100 syringe
  • What do I draw for 1.5mg if I used 2.5ml?
  • 1.5 mg reta in units

Your draw

Vial 60 mg
Bacteriostatic water 2.5 mL
Concentration 24 mg/mL
Dose 1.5 mg
Volume to draw 0.063 mL
U-100 syringe 6.3 units
U-40 syringe 2.5 units
Doses per vial 40

Dose chart: 60 mg vial in 2.5 mL

DoseVolumeU-100 unitsU-40 unitsDoses per vial
0.25 mg 0.01 mL 1 0.4 240
0.5 mg 0.021 mL 2.1 0.8 120
0.75 mg 0.031 mL 3.1 1.3 80
1 mg 0.042 mL 4.2 1.7 60
1.5 mg 0.063 mL 6.3 2.5 40
2 mg 0.083 mL 8.3 3.3 30
2.5 mg 0.104 mL 10.4 4.2 24
3 mg 0.125 mL 12.5 5 20
3.5 mg 0.146 mL 14.6 5.8 17
4 mg 0.167 mL 16.7 6.7 15
5 mg 0.208 mL 20.8 8.3 12
6 mg 0.25 mL 25 10 10
7 mg 0.292 mL 29.2 11.7 8
8 mg 0.333 mL 33.3 13.3 7
9 mg 0.375 mL 37.5 15 6
10 mg 0.417 mL 41.7 16.7 6
11 mg 0.458 mL 45.8 18.3 5
12 mg 0.5 mL 50 20 5

Doses that would need more than a full 1 mL syringe are omitted. Use less bacteriostatic water for those.

Common questions

What if I used a different amount of water?
Then the unit number changes. Units depend on concentration, not just dose. Run your actual vial size and water volume through the reconstitution calculator rather than copying a number from a chart that assumes 2.5 mL.
Is that on a U-100 or U-40 syringe?
6.3 units is the U-100 reading, the standard insulin syringe at 100 units to 1 mL. On a U-40 syringe the same 0.063 mL reads 2.5 units.
How many 1.5 mg doses will this vial give?
About 40 doses from a 60 mg vial. Reconstitution volume doesn't change that. It only changes how many units you draw each time.
How long is it good for after mixing?
Refrigerate reconstituted peptide at 36–46°F (2–8°C). Most references give 28–60 days once mixed, depending on the preservative in the bacteriostatic water. Do not freeze it, and inspect for cloudiness or particles before every draw.

Run your own numbers

These figures assume the vial and water volumes named above. Change either one and the units change with it.