0.25mg of Retatrutide from a 30mg vial in 2.5mL: how many units?

Answer

Draw 2.1 units on a U-100 insulin syringe. A 30 mg Retatrutide vial reconstituted with 2.5 mL of bacteriostatic water is 12 mg/mL, so 0.25 mg is 0.021 mL. That vial holds about 120 doses at this strength.

This page also answers

  • How many units is 0.25mg of reta?
  • 0.25mg reta on a U-100 syringe
  • What do I draw for 0.25mg if I used 2.5ml?
  • 0.25 mg reta in units

Your draw

Vial 30 mg
Bacteriostatic water 2.5 mL
Concentration 12 mg/mL
Dose 0.25 mg
Volume to draw 0.021 mL
U-100 syringe 2.1 units
U-40 syringe 0.8 units
Doses per vial 120

Dose chart: 30 mg vial in 2.5 mL

DoseVolumeU-100 unitsU-40 unitsDoses per vial
0.25 mg 0.021 mL 2.1 0.8 120
0.5 mg 0.042 mL 4.2 1.7 60
0.75 mg 0.063 mL 6.3 2.5 40
1 mg 0.083 mL 8.3 3.3 30
1.5 mg 0.125 mL 12.5 5 20
2 mg 0.167 mL 16.7 6.7 15
2.5 mg 0.208 mL 20.8 8.3 12
3 mg 0.25 mL 25 10 10
3.5 mg 0.292 mL 29.2 11.7 8
4 mg 0.333 mL 33.3 13.3 7
5 mg 0.417 mL 41.7 16.7 6
6 mg 0.5 mL 50 20 5
7 mg 0.583 mL 58.3 23.3 4
8 mg 0.667 mL 66.7 26.7 3
9 mg 0.75 mL 75 30 3
10 mg 0.833 mL 83.3 33.3 3
11 mg 0.917 mL 91.7 36.7 2
12 mg 1 mL 100 40 2

Doses that would need more than a full 1 mL syringe are omitted. Use less bacteriostatic water for those.

Common questions

What if I used a different amount of water?
Then the unit number changes. Units depend on concentration, not just dose. Run your actual vial size and water volume through the reconstitution calculator rather than copying a number from a chart that assumes 2.5 mL.
Is that on a U-100 or U-40 syringe?
2.1 units is the U-100 reading, the standard insulin syringe at 100 units to 1 mL. On a U-40 syringe the same 0.021 mL reads 0.8 units.
How many 0.25 mg doses will this vial give?
About 120 doses from a 30 mg vial. Reconstitution volume doesn't change that. It only changes how many units you draw each time.
How long is it good for after mixing?
Refrigerate reconstituted peptide at 36–46°F (2–8°C). Most references give 28–60 days once mixed, depending on the preservative in the bacteriostatic water. Do not freeze it, and inspect for cloudiness or particles before every draw.

Run your own numbers

These figures assume the vial and water volumes named above. Change either one and the units change with it.