0.25mg of Retatrutide from a 24mg vial in 2.5mL: how many units?
Answer
Draw 2.6 units on a U-100 insulin syringe. A 24 mg Retatrutide vial reconstituted with 2.5 mL of bacteriostatic water is 9.6 mg/mL, so 0.25 mg is 0.026 mL. That vial holds about 96 doses at this strength.
This page also answers
- How many units is 0.25mg of reta?
- 0.25mg reta on a U-100 syringe
- What do I draw for 0.25mg if I used 2.5ml?
- 0.25 mg reta in units
Your draw
| Vial | 24 mg |
| Bacteriostatic water | 2.5 mL |
| Concentration | 9.6 mg/mL |
| Dose | 0.25 mg |
| Volume to draw | 0.026 mL |
| U-100 syringe | 2.6 units |
| U-40 syringe | 1 units |
| Doses per vial | 96 |
Dose chart: 24 mg vial in 2.5 mL
| Dose | Volume | U-100 units | U-40 units | Doses per vial |
|---|---|---|---|---|
| 0.25 mg | 0.026 mL | 2.6 | 1 | 96 |
| 0.5 mg | 0.052 mL | 5.2 | 2.1 | 48 |
| 0.75 mg | 0.078 mL | 7.8 | 3.1 | 32 |
| 1 mg | 0.104 mL | 10.4 | 4.2 | 24 |
| 1.5 mg | 0.156 mL | 15.6 | 6.3 | 16 |
| 2 mg | 0.208 mL | 20.8 | 8.3 | 12 |
| 2.5 mg | 0.26 mL | 26 | 10.4 | 9 |
| 3 mg | 0.313 mL | 31.3 | 12.5 | 8 |
| 3.5 mg | 0.365 mL | 36.5 | 14.6 | 6 |
| 4 mg | 0.417 mL | 41.7 | 16.7 | 6 |
| 5 mg | 0.521 mL | 52.1 | 20.8 | 4 |
| 6 mg | 0.625 mL | 62.5 | 25 | 4 |
| 7 mg | 0.729 mL | 72.9 | 29.2 | 3 |
| 8 mg | 0.833 mL | 83.3 | 33.3 | 3 |
| 9 mg | 0.938 mL | 93.8 | 37.5 | 2 |
Doses that would need more than a full 1 mL syringe are omitted. Use less bacteriostatic water for those.
Common questions
- What if I used a different amount of water?
- Then the unit number changes. Units depend on concentration, not just dose. Run your actual vial size and water volume through the reconstitution calculator rather than copying a number from a chart that assumes 2.5 mL.
- Is that on a U-100 or U-40 syringe?
- 2.6 units is the U-100 reading, the standard insulin syringe at 100 units to 1 mL. On a U-40 syringe the same 0.026 mL reads 1 units.
- How many 0.25 mg doses will this vial give?
- About 96 doses from a 24 mg vial. Reconstitution volume doesn't change that. It only changes how many units you draw each time.
- How long is it good for after mixing?
- Refrigerate reconstituted peptide at 36–46°F (2–8°C). Most references give 28–60 days once mixed, depending on the preservative in the bacteriostatic water. Do not freeze it, and inspect for cloudiness or particles before every draw.
Run your own numbers
These figures assume the vial and water volumes named above. Change either one and the units change with it.